@ F-40 U-40 ‚ΜŽd—l


@
Sensor Specifications F-40 U-40
Imager Type CMOS integrating active pixel sensor(APS),
With on-chip uniformity correction
Sensor type Monochrome
Resolution 1280 X 1024
Region of Interest(ROI) Any rectangle or line image format specified by the user
Active image area 8.96mm(H) x 7.17mm(V)
Pixel pitch / Fillfactor 7 x 7 ƒΚm / 60%(no microlenses)@
Spctral response better than 30%
Temporal noise 20 electrons, 500 microV RMS
Well Capacity More than 75000 electrons (55000 linear range)
Dark current signal 787 electrons/second @ 21‹C
AveDauto-saturation time 51 seconds @ 21‹C
Dark current 255pA/cm2 @21Ž
Smear None
Standard dynamic range 68 dB (55,000/20 = 2750:1) linear, 70 dB enhanced linear
High dynamic range 100 dB in Limited Exposure Technology (LET) mode
Gray level resolution 8 bits / 10 bits / 12bits
Image Specifications
Pixel rate 20 MHz
Frame rate Full resolution approx. 14 frames/second
Shutter Rolling shutter
Shutter synchronisation Remote via software or via cable, local via I/Ointerface
Maximum Exposure time 200 seconds
Minimum exposure time 2 lines, 135 ƒΚsec typical at 20 Mhz@
Interface Specifications F-40 U-40
intrerface type IEEE-1394 Firewire USB 2.0
Interface connector Standard. 6-pole Binder 712 series 4-pole
Cable lengths max 4.5m 5m
Local Trigger Isolated, 1 input, 1 output Isolated, 1 input, 1 output
Local Trigger Connector Binder 712 series 3-pole Binder 712 series 3-pole
Mechanical
Dimensions 51 x 51 x 57 mm 51 x 51 x 57 mm
Weifht 220g 205g
Mounting 8 x M4 threaded holes
2 holes on 4 sides of unit)
8 x M4 threaded holes
2 holes on 4 sides of unit)
Power
Voltage Power Supply via Firewire cable Power Supply via USB cable
Power Consumption <2W <2W
Environmental
Operating Temperature @0‹ to 50‹C , Humidity: 10-90%, non-condensing
Storage -30‹ to 80‹C, Humidity: 10-90%, non-condensing
@


[(Š”j΅Μίèς֖⍇‚Ή]